焦作炯移教育咨询有限公司|免费+无码+国产在看果冻传媒-日韩av电影在线观看-中文字幕免费高清电视剧网站

Company News Industry News

Shrinkage

2022-01-28
Shrinkage is a type of casting defect resulting due to formation of shrinkage cavity as such due to lack of design and insufficient feed metal. Shrinkage results due to formation of a closed loop at a specific point during solidification which creates a cavity because of absence of feed of molten metal. Shrinkage can be classified into three types as open (macro porosity), closed (internal/blind shrinkage) and axial shrinkage. Open shrinkage appear on the exterior of casting surface resulting due to volume contraction from liquid to solid state. These are visualized as shallow cavities on casting surface. Closed Shrinkage results due to dense network of dendritic crystals which restricts void feeding of thick sections. Axial shrinkage is a result of long freezing time at the centerline of casting due to high pouring temperature.


Causes


? Incorrect Gating & Feeding System

? Low Carbon Equivalent
? Lack of Mold Rigidity
? High Pouring Temperature
? Excessive inoculation
? High Phosphorus content in the liquid metal
? Cope mold lifting
? Insufficient super heating & holding
? High steel scrap in the charge
? Poor casting design
? Maximum hot spots
? Lack of chills& placement

? Riser not properly located.


Remedies


? Improvement of gating & feeding by simulation

? Improvement in carbon equivalent
? Increase mold Rigidity by proper ramming
? Avoid excessively high pouring temperature
? Restrict the amount of inoculants to the minimum level
? Control of phosphorus below 0.15%.
? Clamp the mold adequately
? Superheat the metal in the range of 1480-1500 degree & holds for sufficient time after inoculation.
? Cut down the percentage of Steel scrap
? Improve casting design
? Minimize hot spots
? Chills are placed adequately

? Riser are placed properly


ABOUT  KEVA
Keva Casting is a professional casting company that focuses on Construction, Machinery, Automobile, Hardware, Pipeline and many other industries.
We provide top quality products with the best service based on our complete production chain including our own mold design, advanced production techniques, and full management of the supply chain. Keva Casting has two factories located in Zhucheng, China's Shandong province.
We use "shell molding", which is a new technique that has been developed in recent years.This new technique has simplified production procedures and reduced air pollution compared with traditional sand casting and investment casting. Shell making and core making are faster to ensure production in enormous quantities. The dimensions and surface finishing are satisfactory for all kinds of industrial requirements. Besides supplying our own formwork & scaffolding systems, our casting products also supply OEM services in various industries.